User manual

5-172 N9360A Multi UE Tester GSM User Manual
5 Screen Reference
Also, the following information is shown in the screen field:
• MAC Address
• Serial No.
• Option: Displays the option number(s) which is/are installed
in the Tester.
Configuration: Test Sequence Screen
When the Test S equ e nce softkey on the [Configuration] screen is
pressed, the [Configuration: Test Sequence] screen as
Figure 5-75 is displayed.
Configure a test sequence for executing Automatic Test on this
screen.
Loss
*
Sets the path losses caused by the coupler or cable used to connect the RF signals from/to the mobile
phone with each radio systems, respectively.
Selects On or Off.
• On: Adds a set path loss value of RF In/Out. Select On to activate the change of ATT setting on the
[Configuration: Test Sequence] screen.
• Off: Not add the path loss value.
Depending on transmitter testing and receiver testing, set loss values in the RF In and RF Out fields
as follows:
• RF In: Sets the traffic channel loss values for transmitter testing. The allowable range is from 0.0
to 99.9 dB in 0.1 dB steps.
• RF Out: Sets the traffic channel loss for receiver testing. The allowable range is from 0.0 to 99.9
dB in 0.1 dB steps.
The sum of Loss setting value and ATT setting value should be more than or equal to 0. The value less
than 0 is ineffective. Refer to Actual Input/Output Level and Correction on page 17.
Printer Sets the output direction of print screen to USB Memory or EPSON PM-G800.
• USB Memory: Saves a graphic file of screen in a USB memory device. The image format is PNG.
• EPSON PM-G800: Prints a hardcopy of screen in the specified printer.
Beeper Sets beep.
Selects On or OFF.
• On: Beeps for each step of operation.
• OFF: Beeps are suppressed.
Serial No. Displays the serial number of the Tester.
* The toggling magnification softkey menu is displayed. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey
on page 13.
Table 5-74 [Configuration] Screen Input Field
Input Field Description