User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-141
Message Field
The following message is displayed in the message field on the
[Stand-by] screen:
Set mobile phone to TX mode and Press {Trigger}.
The word surrounded by {} in the message field denotes the
softkey.
Explanation
Measurement starts by the following ways:
When the trigger mode is set to
Sing,
• Press the Trigger softkey on the [Stand-by] screen to start
single measurement.
• Press the Tri gger Si ng/C ont softkey on the [Stand-by] screen to
start continuous measurement.
When the trigger mode is set to
Cont,
• Continuous measurement starts on the [Measuring] screen
as soon as the screen of [TX Analyzer] is displayed.
Table 5-61 TX Analyzer Measurement Item
Screen Field Description
Peak TX Power
Burst Timing
Power Ramp
Measurement results of Peak TX Power, Burst Timing and Power Ramp are shown.
When this field is selected, the Graph/Value screen for Peak TX Power/ Burst Timing/ Power
Ramp is displayed with measurement results on text and graph display.
Phase Error (RMS)
Phase Error (Peak)
Frequency Error
Measurement results of Phase Error and Frequency Error are shown.
When this field is selected, the Graph/Value screen for Phase Error/ Frequency Error is displayed
with measurement results on text and graph display.
EVM (RMS)
EVM (Peak)
EVM (95%)
Frequency Error
Origin Offset Spr.
*
Measurement result of EVM, Phase Error, and Origin Offset Spr. are shown.
When this field is selected, the Graph/Value screen for EVM/ Frequency Error/OOS is
displayed with measurement results on text and graph display.
* Installation of the Option G03 is required.