User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-139
Softkey Menu 2
• Print Screen: Prints a hardcopy of the screen or saves a graphic
file of the screen in a USB memory device
depending on the setting of the Printer input
field on the [Configuration] screen.
• More (2 of 2): Returns to the softkey menu 1.
Screen Fields
Set the input fields in the screen field according to the following
description of Table 5-60 to execute a new test.
Table 5-60 [TX Analyzer: Stand-by] Screen Input Field
Input Field Description
Measuring
mode
Sets whether or not to execute a group of test items.
• Peak TX Power, Burst Timing, Power Ramp
• Phase Error (RMS), Phase Error (Peak), Frequency Error
• (Above items can be measured at Demod: GMSK)
• EVM (RMS), EVM (Peak), EVM (95%), Frequency Error, Origin Offset Spr.
• (Above items can be measured at Demod:8PSK, Signal: Burst, Installation of Option G03 is
required.)
Procedure Displays a list of parameter file names stored in the Tester.
If the Tester is using a parameter file, the file name is displayed in this field. If the Tester contains
parameter files, a list of those filename is displayed in this field for selection.
Radio System Selects a radio system from GSM850, GSM900, DCS1800 and PCS1900.
RFCH
*
Sets the broadcast control channel number.
The allowable range is as follows:
GSM850: 128 to 251
GSM900: 0 to 124 and 955 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
Signal Selects CW or Burst of a MS transmission signal.
• CW: Selects this when a continuous wave is transmitted from the mobile phone.
• Burst: Selects this when a bursted signal is transmitted from the mobile phone.