User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-137
TX Analyzer
Feature of TX Analyzer
• All test items are measured without signaling process.
• This mode is used to test the RF transmission characteristics
of mobile phones in a real-time.
Setting for TX Analyzer in the Configuration Mode
• Limits of measurement item:
Each measurement item can be measured and analyzed with
the measurement limits set on the [Configuration: Test
Condition] screen.
• Loss:
The path loss value for each radio system can be set on the
[Configuration] screen to correct the RF attenuation
between the mobile phone and the Tester.
Setting for TX Analyzer in the Signal Generator Mode
• The setting of
RF ON/OFF and Amplitude works with those
on the [Signal Generator] screen.
Stand-by Screen
When the TX Analyzer softkey is pressed on the [Initial] screen,
the [TX Analyzer: Stand-by] screen as Figure 5-63 is displayed:
NOTE
For numeric value entry, the changing magnification softkey is available.
Refer to
Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
The default state is the last setting stored in the internal memory before
power off.