User manual
Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-127
The measurement items are shown in the screen field.
PDTCH
*
Sets a packet data traffic channel number.
The allowable range is as follows:
GSM850: 128 to 251
GSM900: 0 to 124 and 955 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
EVM Meas.
Count
Sets Measurement Burst during EVM test, ranging from 1 to 200.
PWR CNTL Sets one of the factors defined for Power Control Levels according to the Radio System. The allowable
range is as follows:
GSM850, GSM900: 2 to 19 (+39dBm to +5dBm)
DCS1800: 29 to 15 (+36dBm to 0dBm)
PCS1900: 30 to 15 (+33dBm to 0dBm)
Set the MS Power Class on the [Configuration: Test Condition] screen for the power class of the mobile
phone. If the mobile phone does not support the power control function, measurement result is not
displayed.
BS Level
*
Sets the RF output level of the Tester, ranging from -110.0 to -50.0 dBm in 0.1 dB step. The
default value is set on the [Configuration: Test Condition] screen.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-52 [Manual Test] EGPRS Mode EVM Screen Input Field
Input Field Description
Table 5-53 [Manual Test] EGPRS Mode EVM Screen Field
Screen Field Description
EVM RMS Measured EVM (RMS) and the HI Limit are shown. The HI Limit is set on the [Configuration: Test
Condition] screen.
EVM Peak Measured EVM (Peak), the HI and the LO Limit are shown. A set of the HI and the LO Limit is set
on the [Configuration: Test Condition] screen.
EVM 95% Measured EVM (95%) and the HI Limit are shown. The HI Limit is set on the [Configuration: Test
Condition] screen.
Marker Measured Phase Error at the marker position, the HI and the LO Limit are shown. Measured data
is shown when the marker is placed on the measurement trace. The HI Limit is set on the
[Configuration: Test Condition] screen.
Freq. Err Measured Frequency Error, the HI and the LO Limit are shown. The HI and the LO Limit are set on
the [Configuration: Test Condition] screen.
OOS Measured Origin Offset, the HI and the LO Limit are shown. The HI and the LO Limit are set on
the [Configuration: Test Condition] screen.