User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-97
The measurement items are shown in the screen field.
Sensitivity in BLER
The measured data for BLER (block error rate) is shown as
Figure 5-50.
Any data indicating a failure is highlighted.
PDTCH
*
Sets a packet data traffic channel number.
The allowable range is as follows:
GSM850: 128 to 251
GSM900: 0 to 124 and 955 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
PWR CNTL Sets one of the factors defined for Power Control Levels according to the Radio System. The allowable
range is as follows:
GSM850, GSM900: 2 to 19 (+39dBm to +5dBm)
DCS1800: 29 to 15 (+36dBm to 0dBm)
PCS1900: 30 to 15 (+33dBm to 0dBm)
Set the MS Power Class on the [Configuration: Test Condition] screen for the power class of the mobile
phone. If the mobile phone does not support the power control function, measurement result is not
displayed.
BS Level
*
Sets the RF output level of the Tester, ranging from -110.0 to -50.0 dBm in 0.1 dB step. The
default value is set on the [Configuration: Test Condition] screen.
Averaging
*
Sets the averaging number from 2 to 99 or Off. When this function is not required, select Off.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-36 [Manual Test] GPRS Mode Phase Error/Frequency Error Screen Input Field
Input Field Description
Table 5-37 [Manual Test] GPRS Mode Phase Error/Frequency Error Screen Field
Screen Field Description
RMS Measured Phase Error (RMS) and the HI Limit are shown. The HI Limit is set on the
[Configuration: Test Condition] screen.
Phase Peak Measured Phase Error (Peak), the HI and the LO Limit are shown. A set of the HI and the LO
Limit is set on the [Configuration: Test Condition] screen.
Marker Measured Phase Error at the marker position, the HI and the LO Limit are shown. Measured data
is shown when the marker is placed on the measurement trace. The HI Limit is set on the
[Configuration: Test Condition] screen.
Freq. Err Measured Frequency Error, the HI and the LO Limit are shown. The HI and the LO Limit are set on
the [Configuration: Test Condition] screen.