User manual

5-94 N9360A Multi UE Tester GSM User Manual
5 Screen Reference
The measurement results are shown in the screen field.
The RMS and Peak Phase Error and Frequency Error are shown
along with the marker readout if the marker is activated.
If the measured data exceeds the limits on the graph, one or
more white triangle markers indicate the failed position at the
top of the graph frame.
Any data indicating a failure is highlighted.
BS Level
*
Sets the RF output level of the Tester, ranging from -110.0 to -50.0 dBm in 0.1 dB step. The
default value is set on the [Configuration: Test Condition] screen.
Averaging
*
Sets the averaging number from 2 to 99 or Off. When this function is not required, select Off.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-34 [Manual Test] GPRS Mode Peak TX Power/ Burst Timing/Power Ramp Screen Input Field
Input Field Description
NOTE
A Pass/Fail judgment is not given while transmission power is off.
Table 5-35 [Manual Test] GPRS Mode Peak TX Power/Burst Timing/Power Ramp Screen Field
Measurement Item Description
Peak TX Power Measured Peak TX Power, the HI and the LO Limit are shown. The HI and the LO Limit are set on
the [Configuration: Test Condition] screen.
Burst Timing Measured Burst Timing, the HI and the LO Limit are shown. The HI and the LO Limit are set on
the [Configuration: Test Condition] screen.
Power Ramp Measured Power Ramp, the HI and the LO Limit are shown. The limits are specified by the radio
system selected (template).