User manual

5-86 N9360A Multi UE Tester GSM User Manual
5 Screen Reference
The information from the mobile phone is displayed on the left
side of the screen.
Message Field
The following message is displayed in the message field on the
[Measuring] screen:
Press the desired softkey.
Explanation
The Connect process starts and measurement is executed with
the following ways:
• Press the Trigger softkey to execute single measurement.
• Press the Trigger Sing/Cont softkey to change the trigger mode
from
Sing to Cont in order to execute continuous
measurement.
Measur Slot When the Slot Config is set to 2×2 or 3×2, this field becomes a settable field.
Selects measurement slot from 2 to 4 depending on the setting of the Slot Config.
Test Mode Selects from ACK, A, or B.
ACK: Measurement of Peak TX Power, Phase Error, Frequency Error, and BLER
A: Measurement of Peak TX Power, Phase Error, and Frequency Error
B: Measurement of Peak TX Power, Phase Error, Frequency Error and BER. Active in Unacknowledged
Mode for UL/DL.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-32 [Manual Test: Measuring] GPRS Mode Screen Input Field
Input Field Description
Table 5-33 [Manual Test] GPRS Mode Attached Screen Mobile Phone Information
Item Information Description
IMSI Displays the International Mobile Subscriber Identity from the mobile phone.
IMEI Displays the International Mobile station Equipment Identity from the mobile phone.
Multislot Class Displays the Multislot Class of the Mobile phone, ranging from 1 to 12.
RF Power Capability Displays the power class for each Radio System, ranging from 1 to 5.