User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-79
Slot Configuration and Measurement Slot
The combination of the slot configuration and the order of
measurement slot are follows:
Test S I M
Insert the Test SIM provided by Agilent in the mobile phone
before performing any test because the Tester will not be able to
perform measurements with a SIM that is provided by cell
phone operator or other Test SIMs.
Stand-by Screen
When the GPRS is selected in the GSM mode from the
[Configuration: Test Condition] screen, the following [Manual
Test: Stand-by] screen is displayed.
Slot Config and Measurement Slot fields are additionally available
for GPRS measurements.
Table 5-28 Slot Configuration and Measurement Slot
Slot Configuration Measurement Slot
1×12
2×1, 3×13
2×22 or 3
3×23 or 4
4×14
NOTE
For numeric value entry, the changing magnification softkey is available.
Refer to Storing Numeric Values on page 8 and Changing Magnification
Softkey on page 13. The default state is the last setting stored in the
internal memory of the Tester before power off.