User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-77
The data and the message from/to the mobile phone are shown
in this field.
Message Field
The following message is displayed in the message field:
Press {SMSCB}, {SMSMT}, or dial and call from the mobile.
The word surrounded by {} in the message field demotes the
softkey.
BS Level
*
Sets the RF output level of the Tester, ranging from -110.0 to -50.0 dBm in 0.1 dB step. The
default value is set on the [Configuration: Test Condition] screen.
Caller ID Displays addresser number sent from the Tester at BS Call execution. The set value is displayed at this
state.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-26 [Manual Test] GSM Mode SMS Screen Input Field
Input Field Description
Table 5-27 [Manual Test] GSM Mode SMS Information
Item Information Description
IMSI Displays the International Mobile Subscriber Identity from the mobile phone.
IMEI Displays the International Mobile station Equipment Identity from the mobile phone.
Caller ID Displays addresser number sent from the Tester at BS Call execution.
Dialed No. Displays the number dialed from the mobile phone.
GSM Version Displays either Phase 1 or Phase 2 defined by the mobile phone.
Power Class Displays power class information of the mobile phone. Refer to Power Classes on page 2.
ACT Tim ADV Displays the number of bits for the actual timing advance data.
Receive Message Displays the message received from the mobile phone. The number of received characters is up
to 160 characters (ASCII).
Send Message Displays the message sent to the mobile phone. The number of sendable characters is up to 160
characters (ASCII).
NOTE
Remote Control application (provided by user) is required to change the
Send Message.