User manual

Screen Reference 5
N9360A Multi UE Tester GSM User Manual 5-49
The information from the mobile phone as Table 5-15 is
displayed on the left side of the screen.
The RF On indicator is displayed at the screen lower left corner
only when the RF signal from the Tester is present at the RF
IN/OUT connector.
Table 5-14 Manual Test GSM Mode Measurement Item
Measurement Item Description
Peak TX Power
Burst Timing
Power Ramp
Measurement results of Peak TX Power, Burst Timing and Power Ramp are shown.
When this field is selected, the Graph/Value screen for Peak TX Power/ Burst Timing/ Power
Ramp is displayed with the measurement results on text and graph display.
Phase Error (RMS)
Phase Error (Peak)
Frequency Error
Measurement results of Phase Error and Frequency Error are shown.
When this field is selected, the Graph/Value screen for Phase Error/ Frequency Error is displayed
with the measurement results on text and graph display.
Sens/BER II
Sens/FER
Measurement results of Sensitivity/BER and Sensitivity/FER are shown.
When this field is selected, the Graph/Value screen for Sensitivity/ RX Quality/ RX Level is
displayed with the measurement results on text display.
Table 5-15 [Manual Test: Stand-by] GSM Mode Screen Mobile Phone Information
Item Information Description
IMSI Displays the default value of International Mobile Subscriber Identity. The default value is
001012345678901.
IMEI This field remains blank at this state.
Caller ID Displays addresser number sent from the Tester at BS Call execution. The set value is displayed
at this state.
Dialed No. This field remains blank at this state.
Power Class This field remains blank at this state.
GSM Version This field remains blank at this state.
RX Quality This field remains blank at this field.
RX Level This field remains blank at this field.
ACT Tim ADV This field remains blank at this field.