User manual

5-22 N9360A Multi UE Tester GSM User Manual
5 Screen Reference
The word surrounded by {} in the message field denotes the
softkey.
Measuring Screen
When the Start softkey is pressed on the [Automatic Test:
Stand-by] screen, a [Automatic Test: Measuring] screen is
displayed and then a test starts.
The status of sequences is shown in the upper left corner of the
screen. The sequence under test execution is underlined.
One of the test flow steps is highlighted to show which step is
currently being tested. While the RF Test step is highlighted,
each of the measurement items is highlighted sequentially to
obtain a measurement result.
The test result of sequences and signaling steps are shown as
follows:
• P: Shown on blue background when the test is passed.
• F: Shown on red background when the test is failed.
During test, any of the [Automatic Test: Measuring] simple
screen (Figure 5-13), the [Automatic Test: Measuring] detailed
screen (Figure 5-14), or the [Automatic Test: Measuring] value
screen (Figure 5-15) is displayed, according to the setting of the
Simple, the Detail or the Value softkey.