User manual

5-20 N9360A Multi UE Tester GSM User Manual
5 Screen Reference
Table 5-4 describes measurement items in Automatic Test. The
limits for measurement items can be set on the [Configuration:
Test Condition] screen.
TCH (Talk)
*
Sets a traffic channel number for Talk tests.
The allowable range is as follows:
GSM850: 128 to 251
GSM900: 0 to 124 and 955 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
TCH
*
Sets up to the six traffic channels number for RF tests. The allowable range is as follows:
GSM850: 128 to 251
GSM900: 0 to 124 and 955 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 8 and Changing Magnification Softkey on
page 13.
Table 5-3 [Automatic Test: Stand-by] Screen Input Field
Input Field Description
Table 5-4 Automatic Test Measurement Item
Measurement Item Description
Peak TX Power (High) Measures and analyzes the peak transmission level on the PWR CNTL High condition set on
the [Configuration: Test Condition] screen.
Peak TX Power (Mid) Measures and analyzes the peak transmission level on the PWR CNTL Mid condition set on the
[Configuration: Test Condition] screen.
Peak TX Power (Low) Measures and analyzes the peak transmission level on the PWR CNTL Low condition set on
the [Configuration: Test Condition] screen.
Burst Timing Measures and analyzes the burst timing of transmission signal.
Power Ramp Measures and analyzes amplitude envelope of the RF burst signal in the timeslot.
Phase Error (RMS) Measures and analyzes the RMS (Root Mean Square) phase error over the active part of the
timeslots between 0 to 147 bits.
Phase Error (Peak) Measures and analyzes the peak phase error over the active part of the timeslots between 0 to
147 bits.
Frequency Error Measures and analyzes the frequency error over the active part of the timeslots.
Sensitivity/BER II Measures and analyzes the receiving sensitivity by the measurement of the BER (Bit Error
Rate) using the loopback function.
Sensitivity/FER Measures and analyzes the receiving sensitivity by the measurement of the FER (Frame Error
Rate) using the loopback function.