User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-65
Testing a Mobile Phone by TX Analyzer
This section describes the operation method of the Tester for a
test by the TX Analyzer.
1 Turn on the Tester and select the cdma2000 system on the
[Top Menu] screen. Refer to Selection of System on page 4-14
for selecting a system.
2 The [Initial] screen as Figure 4-54 is displayed after
completion of initialization and self-test routine of the Tester.
3 Set the path loss values. Press the Config, Test Cond i ti o n and
then the Loss softkeys from the [Initial] screen to display the
[Configuration: Test Condition (Loss)] screen specifying the
Loss value. Refer to Entering Loss on the Configuration: Test
Condition (Loss) Screen on page 4-22.
Figure 4-54 [Initial] Screen