User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-53
Testing a Dual Band Mobile Phone by Manual Test (1xEV-DO Mode)
This section describes the operation method of the Tester and a
dual band (PCS US and Cel US) mobile phone under the test by
the Manual Test
1xEV-DO mode. Set the mobile phone to
1xEV-DO Only mode before measurement.
1 Turn on the Tester and select the cdma2000 system on the
[Top Menu] screen. Refer to Selection of System on page 4-14
for selecting a system.
2 The [Initial] screen as Figure 4-43 is displayed after
completion of initialization and self-test routine of the Tester.
When CDMA Mode is not set to 1xEV-DO, switch to 1xEV-DO
mode by pressing CDMA Mode >> and then 1xEV-DO softkeys.
3 Set the path loss value. Press the Config, Test Condition and the
Loss softkeys from the [Initial] screen to display the
Figure 4-43 [Initial] Screen