User manual

4-50 N9360A Multi UE Tester CDMA2000 User Manual
4 Operating Procedure
11
Set appropriate test limits in the cells of the test item table in
the upper right side of Figure 4-40.
12 Repeat step 8 to step 11 to set the test condition for Cel US
after replacing B1:PCS US with B0:Cel US in Band field.
13 Press the Return softkey three times and then the Automatic
Tes t softkey to start Automatic Test. The [Automatic Test:
Stand-by] screen as Figure 4-41 is displayed. Press the
Screen>> softkey to select the display mode. Select Simple,
Detail or Value softkey. The following Figure 4-41 is a value
screen which will show the measured value for each
measurement item.
Figure 4-40 [Configuration: Test Condition (Limit)] Screen (1xEV-DO)