User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-49
5
Set CDMA2000 1xEV-DO in Radio System 1 and 2, respectively,
and set other fields as shown in Figure 4-37 and Figure 4-38.
6 Set Run at test item field which you want to execute in the
test flow.
7 Set Run at measurement item cell which you want to measure
in the measurement item table.
8 Press the Return softkey and then the Test Condition softkey to
display the [Configuration: Test Condition] Screen as
Figure 4-39 to set the test condition.
9 Set the fields of the test parameters as shown in the left and
upper right side of Figure 4-39 with the CURSOR CONTROL
knob.
10 Press the Limit softkey to display the [Configuration: Test
Condition (Limit)] Screen (1xEV-DO) as Figure 4-40.
Figure 4-39 [Configuration: Test Condition] Screen (1xEV-DO)