User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-47
3
Set the path loss value. Press the Config, Test Condition and the
Loss softkeys from the [Initial] screen to display the
[Configuration: Test Condition (Loss)] screen specifying the
Loss value. Refer to Entering Loss on the Configuration: Test
Condition (Loss) Screen on page 4-22.
4 Press the Return softkey twice and then the Te s t S e q ue nce
softkey to display the [Configuration: Test Sequence] screen
for required setting in Automatic Test.
Figure 4-36 [Configuration: Test Condition (Loss)] Screen