User manual

ii N9360A Multi UE Tester CDMA2000 User Manual
4 Operating Procedure
Test Flow 4-2
Figure 4-1. Test Flow 4-2
Preparation for Each Test 4-3
System Requirement 4-3
Figure 4-2. Typical Test Setup of the Tester 4-3
Connection 4-3
Figure 4-3. Connecting a Printer 4-5
Figure 4-4. Connecting a USB-GPIB Converter 4-6
Test Procedure 4-7
Activating the Tester 4-7
General Operation 4-7
Figure 4-5. Display Annotation 4-7
Table 4-1. Description of the Display Annotation 4-8
Figure 4-6. Value Storage Softkeys 4-10
Figure 4-7. Memory Function 4-11
Figure 4-8. Value Storage Softkeys 4-12
Figure 4-9. Changing Magnification Softkey 4-13
Selection of System 4-14
Figure 4-10. [Top Menu] Screen 4-14
Figure 4-11. [Initial] Screen MC-1x Mode 4-15
Figure 4-12. [Initial] Screen 1xEV-DO Mode 4-16
Selection of the Function Mode on the Initial Screen 4-17
Figure 4-13. [Initial] Screen MC-1x Mode 4-17
Selection of Protocol Revision 4-18
Table 4-2. Relationship of MC-1x/1xEV-DO protocol and 3GPP2 Config 4-18
Correction 4-19
Figure 4-14. [Configuration: Test Condition (Loss)] Screen 4-22
Figure 4-15. [Configuration: Test Sequence)] Screen 4-24
Testing a Dual Band Mobile Phone by Automatic Test (MC-1x Mode) 4-25
Figure 4-16. [Initial] Screen 4-25
Figure 4-17. [Configuration: Test Condition (Loss)] Screen 4-26
Figure 4-18. [Configuration: Test Sequence1] Screen 4-27
Figure 4-19. [Configuration: Test Sequence2] Screen 4-27
Figure 4-20. [Configuration: Test Condition] Screen 4-28
Figure 4-21. [Configuration: Test Condition (Limit)] Screen 4-29
Figure 4-22. [Automatic Test: Stand-by] Value Screen (MC-1x) 4-30
Figure 4-23. [Automatic Test: Stand-by] Value Screen (MC-1x) 4-31
Testing a Dual Band Mobile Phone by Manual Test (MC-1x Mode) 4-33
Figure 4-24. [Initial] Screen 4-33
Figure 4-25. [Configuration: Test Condition (Loss)] Screen 4-34
Figure 4-26. [Configuration: Test Condition] Screen 4-35