User manual

4-44 N9360A Multi UE Tester CDMA2000 User Manual
4 Operating Procedure
Emergency Call
1 Follow the process of step 1 to step 11 of Testing a Dual Band
Mobile Phone by Manual Test (MC-1x Mode) and set the
mobile phone to Stand-by status.
2 Set the Service Option to 1, 3 or 17.
3 Dial an emergency call number and press an Off Hook button
on the mobile phone to start MS Call.
4 After MS call starts, the screen as Figure 4-34 will be
displayed. Emergency Call with dialed number is displayed
at the Dialed No. field on the screen. P is shown at the MS Call
step, and Connection is highlighted. (The Emergency Call
message is displayed only when the mobile phone supports
the protocol revision 7 and the 3GPP2 Config is set to 2 or 4 for
MC-1x Rel. .A.)
NOTE
To test the emergency call function, place the mobile phone and the
Tester where the radio signal (electromagnetic wave) from base station of
a cell phone operator does not propagate, such as in a shield room, an
anechoic chamber, and etc.