User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-33
Testing a Dual Band Mobile Phone by Manual Test (MC-1x Mode)
This section describes the operation method of the Tester and a
dual band (B1: PCS US and B0: Cel US) mobile phone under the
test by the Manual Test MC-1x mode.
This section shows the example of the Tester operation to test
the mobile phone supporting B1:PCS US and B0:Cel US by using
the Manual Test mode.
1 Turn on the Tester and select the cdma2000 system on the
[Top Menu] screen. Refer to Selection of System on page 4-14
for selecting a system.
2 The [Initial] screen as Figure 4-24 is displayed after
completion of initialization and self-test routine of the Tester.
When CDMA Mode is not set to MC-1x, change to MC-1x
mode by pressing the CDMA Mode >> and MC-1x softkeys.
3 Set the path loss value. Press the Config > Test Condition > Loss
softkeys from the [Initial] screen to display the
Figure 4-24 [Initial] Screen