User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-31
20
At the Talk step, check the quality of loop back voice and
press the Pass or the Fail softkey according to its result.
21 At the BS Release step, the Tester automatically finishes the
call.
22 At the BS Call (RF Test) step, the mobile phone automatically
responds to the call from the Tester.
23 As each step is running in the test flow, the corresponding
test item field in the table is highlighted. While the RF Test
step is highlighted, each of the measurement items is
measured. So, you can see how it is being done.
24 At the System Handoff step, handover PCS US to Cel US. A
screen status changes to Sequence2.
25 After the measurement is completed, a [Stand-by] Value
screen is displayed to show the test results.
Figure 4-23 [Automatic Test: Stand-by] Value Screen (MC-1x)