User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-29
11
Set appropriate test limits in the cells of the test item table in
the upper right side of Figure 4-21.
12 Repeat step 11 to set the test condition for Cel US after
replacing B1:PCS US to B0:Cel US at the Band field.
13 Press the Return softkey three times and then the Automatic
Tes t softkey to start Automatic Test. The [Auto Test:
Stand-by] screen as Figure 4-22 is displayed. Press the
Screen>> softkey to select the display mode. Select Simple,
Detail or Value softkey. The following Figure 4-22 is a value
screen which will show a measured value for each
measurement item.
Figure 4-21 [Configuration: Test Condition (Limit)] Screen