User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-25
Testing a Dual Band Mobile Phone by Automatic Test (MC-1x Mode)
This section describes the operation method of the Tester and a
dual band (B1:PCS US and B0:Cel US) mobile phone under the
test by Automatic Test MC-1x mode.
This section shows the example of the Tester operation to test
the mobile phone supporting B1:PCS US and B0:Cel US by using
the Automatic Test mode. The handover from the B1:PCS US
and B0:Cel US is performed during the test.
1 Turn on the Tester and select the cdma2000 system on the
[Top Menu] screen. Refer to Selection of System on page 4-14
for selecting a system.
2 The [Initial] screen as Figure 4-16 is displayed after
completion of initialization and self-test routine of the Tester.
3 Press Config > Test Condition > Loss softkeys from the [Initial]
screen to display the [Configuration: Test Condition (Loss)]
screen specifying the Loss value.
Figure 4-16 [Initial] Screen