User manual

4-4 N9360A Multi UE Tester CDMA2000 User Manual
4 Operating Procedure
2
Using a User-Supplied RF Cable
If you have a cable which connects between the RF port of
the mobile phone and the RF IN/OUT connector of the Tester,
use it instead of the Antenna Coupler.
3 Using the Shield Case
Connect the ANTENNA COUPLER IN/OUT connector of the
shield case (type N9360A-S01) to the RF IN/OUT connector
on the front panel of the Tester. Place the mobile phone on
the antenna coupler board inside the shield case using the
horizontal and vertical holders.
Connecting a Printer
To print screen hard copies, if required, connect a printer to the
Tester as follows using an appropriate interface cable between
the USB connector on the rear panel of the Tester and the USB
interface connector of the printer. Use the recommended
printer shown below. Also, refer to the manual of the printer for
operating the printer.
Recommended printer (operation confirmed by Agilent):
EPSON PM-G800