User manual

Operating Procedure 4
N9360A Multi UE Tester CDMA2000 User Manual 4-3
Preparation for Each Test
The following procedures are required before starting each test.
System Requirement
The following equipment are required to set up a test system:
• The Agilent N9360A Multi UE Tester.
• An RF cable, RF antenna coupler (type N9360A-A02) to connect RF
signals from/to the mobile phone under test.
• A printer and a printer cable if required.
Connection
Connecting a Mobile Phone
Connect a mobile phone to the Tester using any of the following
methods:
1 Using the Antenna Coupler
Connect the Antenna Coupler (type N9360A-A02) connector
to the RF IN/OUT connector on the front panel of the Tester.
Insert the antenna of the mobile phone into the hole of the
Antenna Coupler.
CAUTION
Make sure that the input signal level does not exceed the maximum
level allowed. Otherwise, an accident or Tester failure may occur.
Figure 4-2 Ty pi c a l Te s t S e t u p o f t h e Te st e r