User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-193
Screen Field
Set the input items required to execute tests, referring to the
description shown in Table 5-54.
Table 5-54[Configuration: Network Setting] screen
Input Item Description
IP Addr Set an IP address of the Tester. Possible values are as follows:
Allowable range of address values
• 1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168.1.255 are unavailable to setting.)
• The IP address setting supports Class A through C.
• It does not support Class D (multicast address) or Class E (reserved address).
• The factory default IP address is 192.168.0.1.
• If setting an IP address fails, Invalid will be displayed in the Status section.
• Changes to the IP address will be effective only after pressing the Apply Address softkey.
CIDR (Mask) Set a subnet mask in CIDR format. Possible values are as follows:
Allowable range of address values:
• 1 to 31
• The factory default mask value is 24 (255.255.255.0).
• If setting a mask value fails, Invalid will be displayed in the Status section.
• Changes to the mask value will be effective only after pressing Apply Address softkey.
Refer to Appendix B General information on cdma2000 system for details.
Default Gateway Set valid/invalid of the default gateway and the address. The allowable setting range is as
follows:
Flag setting range:
• None: Do not set the default gateway.
• ACT: Set the default gateway.
• When you select None, you cannot select the address setting frame.
Allowable range of address values:
• 1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to 192.168. 1.255 are unavailable to setting.)
• The IP address setting supports Class A through C.
• It does not support Class D (multicast address) or Class E (reserved address).
• The default gateway is valid only when you specify IP in the subnet set by IP Addr/Mask
within the address setting range.
• Unreachable is displayed in the Status field when you specify an address outside the
subnet.
• If the Default Gateway is set to None when booting, the address is displayed as (0.0.0.0),
which means invalid.
• If an error occurs in setting the default gateway, Invalid is displayed in the Status field.
• Changes to the default gateway will be effective only after pressing the Apply Address
softkey.