User manual

5-152 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
* A changing magnification softkey is available. Refer to Storing Numeric Values and Changing Magnification Softkey.
Set Run to execute the step, or select --- to skip the step in the
test flow.
Service Option Sets the service option.
Tal k
• 1:Normal Voice
• 3:EVRC 9.6 kVoice
• 17:14.4 k Voice
• 32768:14.4 k Voice
RF Test
• 2:9.6 k Data Loop Back
• 9:14.4 k Data Loop Back
• 55:Data Loop Back
The Radio Config and the Service Option settings of after handoff are same value of before handoff.
When the BS Release at the 7th step in the Sequence 1 is changed to the System Handoff, the Service
Option settings for the Talk and RF Test in the Sequence 2 are same as the Sequence 1
Wait before
Paging
Sets wait time before the BS Call step. The allowable range is as follows:
• 0.0(no wait) to 99.9 seconds(0.1 step).
MS EXT Control Sets the mobile phone control for MS Call, BS Call and MS Release.
• On: Controls the mobile phone
• On: Not control the mobile phone
3GPP System This is the value used by W-CDMA and the set item is provided on the sequence-1 screen regardless of
the radio system setting.
Table 5-43 Input items on the [Configuration: Test Sequence] (continued)Screen (MC-1x)
Input Item Description
Table 5-44 Input items on the [Configuration: Test Sequence] Screen (MC-1x)
Measurement Item Description
Access Probe Power Sets execution or skip the Access Probe Power measurement.
Inner Loop Power Sets execution or skip the Inner Loop Power measurement.
Max TX Power Sets execution or skip the maximum TX power measurement.
Min TX Power Sets execution or skip the minimum TX power measurement.
Frequency Error Sets execution or skip the Frequency Error measurement.
Rho/Multi-code Rho Sets execution or skip the waveform quality (ρ) measurement.