User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-133
The information of Table 5-39 sent from the Tester is displayed
on the screen.
Modulation Specifies the Modulation from the Modulation Data setting and the Modulation Mode setting.
Modulation Data setting:
• MC-1x Mode;
• Pilot Only
• Pilot+Sync+Pch+OCNS+Fch
• Pilot+Sync+Pch+OCNS+Fch+Sch
• 1xEV-DO Mode;
• Cont Pilot
• Pilot+MAC+Cntrl
• Pilot+MAC+Cntrl+Tch
• Other
• Off
• AM Modulation 1
• AM Modulation 2
Modulation Mode setting (Select the modulation mode from the followings when the modulation data is
set to Pilot+MAC+Cntrl+Tch on the 1xEV-DO mode.
• QPSK
• 8PSK
• 16QAM
The Mode setting determines the selectable range of Modulation method. Refer to Appendix D
Parameters of physical channels for combinations of selectable Mode and Modulation method.
Subtype Sets the Subtype. The allowable setting is as follows.
• 0
• 2
Subtype is displayed and available only when the 3GPP2 Config is set to 3 or 4 (1xEV-DO Rev. A), and
the Modulation is set to Pilot+ MAC+ Cntrl+ Tch.
* The toggling magnification softkey menu is displayed. Refer to Storing Numeric Values on page 4-10 and Changing Magnification Softkey
on page 4-13.
Table 5-38 Input field of the [Signal Generator] screen
Input Field Description
Table 5-39 [Manual Test: Measuring] Mobile Phone information on the 1xEV-DO mode connection screen
Item Information Description
Radio System The CDMA2000 message is displayed at lower left of the screen.
3GPP-SYS Displays the value of the 3GPP System that is set on the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.