User manual

5-128 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
• Trigger Sing/Cont: Selects the trigger mode from Sing
(single) and
Cont (continuous).
•If you select the
Cont (Continuous measurement) trigger
mode, the continuous measurement starts immediately
after the [TX Analyzer] screen is displayed.
•Switch the
Cont trigger mode to Sing (Single
measurement) to terminate the measurement.
• Trigger: Performs single measurement when the trigger
mode is set to
Sing.
• More (1 of 2): Displays the Softkey Menu 2.
• Return: Returns to the [Initial] screen.
Softkey Menu 2
• Print Screen: Prints a hardcopy of the screen or saves a
graphic file of the screen in a USB memory device
depending on the setting of the Printer input field on the
[Configuration] screen.
• More (2 of 2): Returns to the Softkey Menu 1.
Screen Field
Set the input fields in the screen field according to the following
description of Table 5-36 to execute a new test.
Table 5-36 Entries on the [TX Analyzer: Stand-by] Code Domain Power Screen (1xEV-DO)
Input Item Description
Measuring
mode
Sets On (measure) or Off (not measure) for each measurement item.
• Pilot, RRI, DRC, ACK, Data, DSC *, Max Inactive Channel
*DSC is displayed only when 3GPP2 Config is set to 3 or 4 (1xEV-DO Rev. A).
When the Code Domain Power (Pilot, RRI, DRC, ACK, DSC, Data, Max inactive Channel) measurement is
set to On, the TX Power measurement is also set to On. When it is set to Off, TX Power measurement
is also set to Off.
Procedure Specifies a parameter file to be used for the test.
This item displays the file name for the parameter file that is currently in use.
It is also possible to select a parameter file from existing parameter files and specify it as the file to be
used for the test.