User manual

5-126 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
Message Field
The following message is displayed in the message field on the
Connection screens:
Press the desired softkey.
Code Domain Power Measuring Screen (1xEV-DO Mode)
During Code Power measurement, all test items are measured
but their acceptance or failure is NOT determined. The Code
Power measuring screens of Figure 5-58 and Figure 5-59 are
displayed if the Modulation mode has been set to Cont Pilot,
Pilot+MAC+Cntr1 or Pilot+MAC+Cntrl+Tch (1xEV-MO mode).
To access the [TX Analyzer: Stand-by] Code Domain Power
Screen (MC-1x) as Figure 5-57, set 3GPP2 Config to
1 or 2, set the
Modulation to either of Pilot Only, Pilot+Sync+Pch+OCNS+Fch and
Pilot+Sync+Pch+OCNS+Fch+Sch (MC-1x mode) on the [Stand-by]
screen (refer to Stand-by Screen), and then press More (1 of 2)
and Code Power softkeys.
Select the
Sing (Single measurement) or Cont (Continuous
measurement) trigger mode and start the measurement.
The Release cannot be set on this screen.
NOTE
Install the C02 option before using test functions of the 1xEV-D0 mode.