User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-125
Information is also displayed in the information display area.
The information of Table 5-35 sent from a mobile phone is
displayed on the screen.
RFCH
*
Specifies the band and channel number. This parameter can be changed when the Stand-by status.
The allowable range of channel number for each band is as follows:
B0 (Cel US): 1024 to 1323 CH, 991 to 1023 CH, 1 to 799 CH
B1 (PCS US): 0 to 1199 CH
B3 (Cel JP): 1041 to 1199 CH, 1201 to 1600 CH, 801 to 1039 CH, 1 to 799 CH
B4 (PCS KR): 0 to 599 CH
B6 (IMT-2K): 0 to 1199 CH
Refer to Appendix B General information on cdma2000 system for details.
Amplitude
*
Sets the RF output level from the Tester between –115.0 and –18.0 dBm in 0.1 dB steps.
Modulation Sets the Modulation to either of the available Modulation Data setting:
Pilot Only
Pilot+Sync+Pch+OCNS+Fch
Pilot+Sync+Pch+OCNS+Fch+Sch
The selectable modulation systems depend on the mode you have selected. For the allowable
combinations of Mode and Modulation system, refer to Appendix D Parameters of physical channels.
Averaging Specifies the average number for the TX Power, Pilot and Traffic (Fundamental) , Max Inactive Channel
measurements.
Sets the averaging number from 2 to 99, or Off.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 4-10 and Changing Magnification Softkey on
page 4-13.
Table 5-34 Entries on the [TX Analyzer: Stand-by] Code Domain Power Screen (MC-1x)
Input Item Description
Table 5-35 Mobile Phone Information on the [TX Analyzer: Stand-by] Code Domain Power Screen (MC-1x)
Item Information Description
Radio System The CDMA2000 message is displayed at lower left of the screen.
3GPP-SYS Displays the value of the 3GPP System that is set on the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.
SIG-PTN Displays the value of the Signaling Pattern that is set on the [Configuration: Test Condition]
screen.
3GPP2-CONF Displays the value of the 3GPP2-Config that is set on the [Configuration: Test Condition] screen.