User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-123
Code Domain Power Measuring Screen (MC-1x Mode)
During Code Power measurement, all test items are measured
but their acceptance or failure is NOT determined. The [TX
Analyzer: Stand-by] Code Domain Power Screen (MC-1x) as
Figure 5-57 appears if the Modulation mode has been set to Pilot
Only, Pilot+Sync+Pch+OCNS+Fch or
Pilot+Sync+Pch+OCNS+Fch+Sch (MC-1x mode).
When you press the More (1 of 2) and Code Power softkeys in
succession on the Stand-by Screen, and [TX Analyzer: Stand-by]
Code Power Screen (in MC-1x Mode) as Figure 5-57 appears and
the measurement becomes ready to start.
Select the
Sing (Single measurement) or Cont (Continuous
measurement) trigger mode and start the measurement.
The Release cannot be set on this screen.
Softkey Menu Field
Softkey Menu 1
• RF Output On/Off: Sets the RF signal output from
On and
Off.
Figure 5-57 [TX Analyzer: Stand-by] Code Power Screen (MC-1x Mode)