User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-121
Result Screen
When the measurement is complete, the [TX Analyzer:
Stand-by] Result Screen is displayed.
The measured results and the acceptance or failure of each item
are displayed at the right to the test item.
•
Pass: Displayed on blue background when the measurement
is passed.
•
Fail: Displayed on red background when the measurement
is failed.
Softkey Menu Field
Softkey Menu 1
• RF Output On/Off: Selects the RF power output from
On and
Off.
• Trigger Sing/Cont: Selects the trigger mode from
Sing
(single) and
Cont (continuous).
•If you select the
Cont (Continuous measurement) trigger
mode, the continuous measurement starts immediately.
•Switch the
Cont trigger mode to Sing (Single
measurement) to terminate the measurement.
• Trigger: Measurement starts after this softkey is pressed
when the trigger mode is set to
Sing.
Figure 5-56 [TX Analyzer: Stand-by] Result Screen