User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-119
The information of Table 5-33 sent from the Tester is displayed
on the screen.
Message Field
The following message is displayed in the message field on the
[TX Analyzer: Stand-by] Screen.
Set mobile phone to TX mode and Press {Trigger}.
The word surrounded by {} in the message field denotes the
softkey.
Description
Measurement starts by the following ways:
When the trigger mode is set to
Sing (Single measurement),
• Press the Tr igg er softkey on the [Stand-by] screen to start
single measurement.
• Press the Trigger Sing/Cont softkey on the [Stand-by] screen to
start continuous measurement.
When the trigger mode is set to
Cont (Continuous
measurement),
• Continuous measurement starts on the [Measuring] screen
as soon as the screen of [TX Analyzer] is displayed.
Table 5-33 TX Analyzer: Stand-by] Screen Information
Item Information Description
Radio System The CDMA2000 message is displayed at lower left of the screen.
3GPP-SYS Displays the value of the 3GPP System that is set on the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.
SIG-PTN Displays the value of the Signaling Pattern that is set on the [Configuration: Test Condition]
screen.
3GPP2-CONF Displays the value of the 3GPP2-Config that is set on the [Configuration: Test Condition] screen.