User manual

5-112 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
• Trigger Sing/Cont: Executes RF test. Selects the trigger
mode from
Sing (single) and Cont (continuous).
•If you select the
Cont (Continuous measurement) trigger
mode, the continuous measurement starts immediately.
•Switch the
Cont trigger mode to Sing (Single
measurement) to terminate the measurement.
• Trigger: Starts measurement during the Connection status.
This softkey is inactivated in the Stand-by status but
activated in the Connection status.
• More (1 of 3): Displays the Softkey Menu 2.
• Return: Returns to the [Initial] screen.
Softkey Menu 2
• Print Screen: Prints a hardcopy of the screen or saves a
graphic file of the screen in a USB memory device
depending on the setting of the Printer input field on the
[Configuration] screen.
• RF Output On/Off: Selects the RF power output from
On and
Off. When it is set to On, the Tester outputs the BS level of
the signal. When it is set to
OFF, the Tester outputs less
than –120 dBm of the signal.
• System >>: Displays the Softkey Menu 4 to select a system.
Pressing this softkey displays each mode of the installed
options.
• Session Close: This softkey menu is unavailable at the
Stand-by status, and become available at the Session
Opened status after UATI Assign completed successfully,
and executes Session Close.
• Code Power: Displays the [Code Domain Power]
measurement screen.
• More (2 of 3): Returns to the Softkey Menu 3.
Softkey Menu 3
• Debug Data > USB: Stores the debug data into the USB
memory device.
• Call Drop Timer On/Off: Sets Call Drop Timer to
On or Off.
• More (3 of 3): Displays the Softkey Menu 1.
Softkey Menu 4