User manual

5-108 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
The information of Table 5-29 sent from a mobile phone and the
Tester is displayed on the screen field.
Message Field
The following message is displayed in the message field on the
[Measuring] Code Domain Power screen.
Press the desired softkey.
Confidence Sets confidence level of the PER Measurement. Selects 95% or Off.
Averaging Specifies the average number of the measurement of the TX Power, Frequency Error, Waveform Quality
(Multi-code Rho), Origin Offset, Time Offset, Max TX Power, Min TX Power and Code Domain Power
measurement.
Sets the averaging number from 2 to 99, or Off.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 4-10 and Changing Magnification Softkey on
page 4-13.
Table 5-28 Entries on the [Manual Test: Measuring] Screen for Code Domain Power Measurement (MC-1x)
Input Item Description
Table 5-29 Mobile Phone Information on the Code Domain Power Screen (MC-1x)
Item Information Description
Procedure The name of currently used parameter file is displayed.
Radio System The CDMA2000 message is displayed at lower left of the screen.
PER FT Rate Displays the downlink data rate of the packet error rate measurement.
3GPP-SYS Displays the value of the 3GPP System that is set on the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.
SIG-PTN Displays the value of the Signaling Pattern that is set on the [Configuration: Test Condition]
screen.
3GPP2-CONF Displays the value of 3GPP2-Config that is set on the [Configuration: Test Condition] screen.