User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-105
Code Domain Power Measuring Screen
Code Domain Power Measurement measures all test items
without the Pass/Fail results.
When you press the More (1 of 2) and Code Power softkeys in the
Connection status (refer to the [Measuring] Screen of
Connection Screen), the [Manual Test: Measuring] Code Domain
Power Screen is displayed as shown in Figure 5-50 (if 3GPP2
Config is set to 1 or 2 (1xEV-DO mode is set to Release 0)) or in
Figure 5-51 (if 3GPP2 Config is set to 3 or 4 (1xEV-DO mode is set
to Release A)) to measure the Code Domain Power.
Select the
Sing (Single measurement) or Cont (Continuous
measurement) trigger mode and start the measurement.
The Connection Close is unavailable on this screen.
Figure 5-50 [Manual Test] Code Domain Power Screen (3GPP2 Config is set to 1 or 2) (1xEV-DO)