User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-103
The information of Table 5-27 sent from a mobile phone is
displayed on the screen.
RFCH
*
Specifies the band and channel number. This parameter can be changed when the stand-by or
Connection status.
The allowable range of channel number for each band is as follows:
• B0 (Cel US): 1024 to 1323CH, 991 to 1023CH, 1 to 799CH
• B1 (PCS US): 0 to 1199CH
• B3 (Cel JP): 1041 to 1199CH, 1201 to 1600CH, 801 to 1039CH, 1 to 799CH
• B4 (PCS KR): 0 to 599CH
• B6 (IMT-2K): 0 to 1199CH
• Setting RFCH in the Connection status starts handoff. Handoff is also available between bands.
Refer to Appendix B General information on cdma2000 system for details.
BS Level
*
Sets the RF output level of the Tester, ranging from -115.0 to -18.0 dBm in 0.1 dB step. The
default value is set on the [Configuration: Test Condition] screen.
PER BS Level Sets the RF output level of the Tester during the packet error rate measurement. The allowable range is
from –115.0 to –18.0 dBm in 0.1 dB step.
PWR CNTL Specifies the power control bit to control TX Power of mobile phone. The allowable setting is as follows:
• HOLD: Sets to HOLD.
• UP: Increases the TX Power of the mobile phone to the specified value. (Not available in the
Stand-by status.)
• DOWN: Decreases the TX Power of the mobile phone to the specified value. (Not available in the
Stand-by status.)
• CNT UP: Sets to Continuous Up.
• CNT DWN: Sets to Continuous Down.
Max Packets
*
Set the number of packets used for PER measurement. The allowable range is from 25 to 10000000 (or
10
7
).
Confidence Selects confidence level of the PER Measurement. Selects 95% or Off.
Averaging Specifies the average number of the measurement of the TX Power, Frequency Error, Waveform Quality
(Multi-code Rho), Origin Offset, Time Offset, Max TX Power, Min TX Power and Code Domain Power
measurement.
Sets the averaging number from 2 to 99, or Off.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 4-10 and Changing Magnification Softkey on
page 4-13.
Table 5-26 Entries on the [Manual Test: Measuring] Connection Screen (1xEV-DO)
Input Item Description