User manual

5-96 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
Stand-by Screen
When the Manual Test softkey is pressed on the [Initial] screen,
the [Manual Test: Stand-by] Screen (1xEV-DO) as Figure 5-48 is
displayed.
Softkey Menu Field
Softkey Menu 1
• UATI Assign: Executes the UATI assignment.
• BS Call: This softkey menu is unavailable at the Stand-by
status, and become available at the Session Opened status
after UATI Assign completed successfully, then executes
BS call.
• Clear Status: Clears (or erases) the pass or fail results in
the test flow.
• Trigger Sing/Cont: Executes RF test. Selects the trigger
mode from
Sing (single) and Cont (continuous).
•If you select the
Cont (Continuous measurement) trigger
mode, the continuous measurement starts immediately.
•Switch the
Cont trigger mode to Sing (Single
measurement) to terminate the measurement.
Figure 5-48 [Manual Test: Stand-by] Screen (1xEV-DO)