User manual

5-82 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
The information from the mobile phone as Table 5-19 is
displayed in the screen field.
Message Field
The following message is displayed in the message field on the
[Stand-by] screen:
Press {Start} to begin a test.
The word surrounded by {} in the message field denotes the
softkey.
Table 5-18 Input Items on [Automatic Test: Stand-by] Screen (1xEV-DO)
Input Field Description
Procedure Specify a parameter file to be used for the test.
This item displays the file name for the parameter file that is currently in use.
It is also possible to select a parameter file from existing parameter files and specify it as the file to be
used for the test.
RFCH
*
Specify the band and channel number. This parameter can be changed when the stand-by status. The
allowable range of channel number for each band is as follows:
• B0 (Cel US): 1024 to 1323CH, 991 to 1023CH, 1 to 799CH
• B1 (PCS US): 0 to 1199CH
• B3 (Cel JP): 1041 to 1199CH, 1201 to 1600CH, 801 to 1039CH, 1 to 799CH
• B4 (PCS KR): 0 to 599CH
• B6 (IMT-2K): 0 to 1199CH
• ----: Skip.
Refer to Appendix B General information on cdma2000 system for details.
* The changing magnification softkey is available. Refer to Storing Numeric Values on page 4-10 and Changing Magnification Softkey on
page 4-13.
Table 5-19 Mobile Phone Information on [Automatic Test: Stand-by] Screen (1xEV-DO)
Item Information Description
ESN Displays the Electronic Serial Number sent from the mobile phone, with Max. 8 digits. This
number cannot be displayed when the status is Stand-by.
3GPP-SYS Displays the value of the 3GPP System that is set in the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.
SIG-PTN Displays the value of the Signaling Pattern that is set in the [Configuration: Test Condition]
screen.
3GPP2-CONF Displays the value of the 3GPP2-Config that is set in the [Configuration: Test Condition] screen.