User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-79
Stand-by Screen
When the Automatic Test is pressed on the [Initial] screen, the
[Auto Test: Stand-by] Simplified Screen (1xEV-DO) is displayed
as shown in Figure 5-37.
Then, any of the [Automatic Test: Stand-by] Simplified Screen
(1xEV-DO) (Figure 5-37), the [Automatic Test: Stand-by]
Detailed Screen (1xEV-DO) (Figure 5-38), or the [Automatic
Test: Stand-by] Value Screen (Figure 5-39) is displayed
according to the setting of the Simple, the Detail and the Value
softkey. (Sensitivity/PER3 is displayed in the RF Test item only
when the 3GPP2-CONF is set to 3 or 4 (ReleaseA). Sensitivity/PER3
is not displayed in the RF Test item and is not measured when
the 3GPP2-CONF is set to 1 or 2 (Release0).)
Figure 5-37 [Automatic Test: Stand-by] Simplified Screen (1xEV-DO)