User manual

5-76 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
Automatic Test (1xEV-DO Mode)
This section explains how to test a mobile phone by Automatic
Test: 1xEV-D0 mode.
Overview
Feature of Automatic Test
• Pass or Fail test results in the test flow and measurement
items are automatically obtained.
• This function executes RF test changing frequencies up to six
channels automatically. Combining Sequence 1 and
Sequence 2 enable measurement up to 12 channels in one
test.
Setting for Automatic Test in Configuration Mode
• Parameters:
The parameters used in Automatic Test are set on the
[Configuration: Test Sequence] and [Configuration: Test
Condition] screens.
• Loss:
The path loss values for each band can be set on the
[Configuration: Test Condition (Loss)] screen to correct the
RF attenuation between the mobile phone and the Tester.
Refer to Actual Input/Output Level and Correction for correction
of input/output signal.
• Tests Limits:
The test limits for each test can be defined on the
[Configuration: Test Condition (Limit)] screen. The test
result (pass or fail) for each test is automatically judged by
using the predefined test limits.
• ATT In/Out:
The path loss values for each traffic channel can be set on the
[Configuration: Test Sequence] screen to correct the RF tests
results at each traffic channel in each band.
NOTE
Install the C02 option to use the test function in the 1xEV-D0 mode.