User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-65
Table 5-14 Mobile Phone Information on [Manual Test: Measuring] Screen (MC-1x)
Item
Information
Description
IMSI Displays the International Mobile Subscriber Identity sent from the mobile phone, with Max. 15 digits.
ESN Displays the international mobile station identity sent from the mobile phone, with Max. 8 digits. This
number cannot be displayed when the state is Stand-by.
Caller ID Displays the dialer number sent from the Tester at BS Call step. Maximum 32 digits, including arbitrary
digits (0 to 9) and symbols (* and #) can be usable. This value can be changed only by using a remote
control command.
Dialed No. During Connection state, the DTMF tone number is added to the right side of the Dialed No. When the
number reaches over 32 digits, the left end number is deleted.
Pilot Strength Displays the pilot channel measured level at the mobile phone between –31.5 and 0.0 dB when the
mobile phone receives the Measurement Report message.
RX Power Displays the pilot channel measured level at the mobile phone between –120 to –18 dBm when the
mobile phone receives the Pilot Strength Measurement message.
This is not measured and not displayed when the RX Power is set to Off.
Access Probe
Power
Measures and displays the access probe TX power of the mobile phone. The display range is from –60
to 36.0 dBm.
This is not measured and not displayed when the Access Probe Meas field on the [Configuration: Test
Condition] screen is set to OFF.
Procedure Displays the file name of the parameter file in current use.
Radio System Displays CDMA2000 on the lower left of the screen.
Service Option Displays the selected service option.
Radio Config Displays the Radio Configuration setting.
SCH Rate Displays the specified SCH rate. This item is displayed only when Radio Config is set to F3R3, F4R3 or
F5R4.
SCH Encoder Displays the specified SCH encode type. This item is displayed only when Radio Config is set to F3R3,
F4R3 or F5R4.
SCH Level Displays the specified SCH level. This item is displayed only when Radio Config is set to F3R3, F4R3 or
F5R4.
3GPP-SYS Displays the value for 3GPP System that is set in the [Configuration: Test Sequence] and the
[Configuration: Test Condition] screens.
SIG-PTN Displays the value for Signaling Pattern that is set in the [Configuration: Test Condition] screen.
3GPP2-CONF Displays the value for 3GPP2-Config that is set in the [Configuration: Test Condition] screen.