User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-59
The RF On indicator is displayed at the screen lower left corner
only when the RF signal from the Tester is present at the RF
IN/OUT connector.
CDT Off is displayed on the lower left of the display only when
the Call Drop Timer is set to
Off.
Message Field
The following message is displayed in the message field on the
[Stand-by] screen:
Press {Loc Update}, {BS Call} or dial and call from the mobile.
The word surrounded by {} in the message field denotes the
softkey.
Description
Before beginning tests, press the Location Update softkey, turn
the mobile phone on and wait until the Location Update step is
change to pass. When the Location Update is passed, set to pass,
P is displayed within the blue background in the Test Results
field of the Location Update test.
After that, there are two ways to start the test.
Receive call of mobile phone (BS Call)
Press the BS Call softkey. The BS Call step is highlighted. Then,
the following test result is displayed in the test result field of the
BS Call step.
• P: Displayed on blue background when the call setup is
executed properly and BS Call is passed.
• F: Displayed on red background when BS Call failed.
Originate call of mobile phone (MS Call)
Dial and press the Off Hook button on the mobile phone. The MS
Call step is highlighted. Accepting a call request from the
mobile-phone will switch to the mobile-phone call connection
hold screen.
Connect Wait Timeout (set in Connect Wait field on the
[Configuration: Test Condition] screen) or press the Answer
softkey to restart the connection sequence.