User manual

5-36 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
Measuring Screen
When the Start softkey is pressed on the [Auto Test: Stand-by]
screen, a [Auto Test: Measuring] Simplified Display Screen as
shown in Figure 5-17 is displayed and then a test starts.
The status of sequences is shown on the upper left corner of the
screen. The sequence under test execution is underlined.
One of the test flow steps is highlighted to show which step is
currently being tested. While the RF Test step is highlighted,
each of the measurement items is highlighted and measured
sequentially to obtain a measurement result.
The test result of sequences and signaling steps are shown as
follows:
• P: Shown on blue background when the test is passed.
• F: Shown on red background when the test is failed.
During test, any of the [Auto Test: Measuring] Simplified Screen
(MC-1x) (Figure 5-17), the [Auto Test: Measuring] Detailed
Screen (MC-1x) (Figure 5-18), or the [Auto Test: Measuring]
Value Screen (MC-1x) (Figure 5-19) is displayed, according to
the setting of the Simple, the Detail or the Value softkey.
Figure 5-17 [Auto Test: Measuring] Simplified Screen (MC-1x)