User manual

Description of Screens 5
N9360A Multi UE Tester CDMA2000 User Manual 5-21
Default Gateway Sets active or inactive of the Default Gateway setting and sets Default Gateway address. The
allowable settings are as follows:
• None: Default Gateway setting is inactivated.
• ACT: Default Gateway setting is activated.
• If you select None, the field to set an address will be grayed out and inactivated.
• 1.0.0.1 to 223.255.255.255.255 (From 192.168.1.1 to 192.168. 1.255 are unavailable to
setting.)
• The IP address setting supports Class A through C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The Default Gateway setting is valid when you set allowable Default Gateway address, and the
Tester and the Default Gateway belong to the same network.
• If you set an address that does not belong to the subnet, Unreachable will be displayed in the
Status section since the routing from this instrument cannot be resolved.
• If the Default Gateway setting is set to NONE when booting, the address will be displayed as
(0.0.0.0), which means invalid.
• If the default gateway setting fails, Invalid will be displayed in the Status field.
• The Default Gateway setting is effective after pressing Apply Address softkey.
Setting 1 through 5 Sets Act/None (active/inactive) of gateway settings from 1 to 5. The allowable setting is as follows:
• None: The Gateway setting is inactivated.
• ACT: The Gateway is activated.
•If you select None, the field to set an address will be grayed out and unavailable.
Host/Net Set the the destination host or network addresses for gateway setting from 1 through 5.
Allowable settings are follows:
• When Host address is specified (CIDR=None): 1.0.0.1 to 223.255.255.255 (From 192.168.1.1 to
192.168.1.255 are unavailable to setting.)
• When Network address is specified (when the CIDR is not set to None): 1.0.0.0 to 223.255.255.255
(From 192.168.1.0 to 192.168.1.255 are unavailable to setting.)
•The IP address setting supports Class A through C.
•The Tester does not support Class D (multicast address) and Class E (reserved address).
•When Gateway setting fails, Invalid will be displayed in the Status field.
•The Host/Net setting takes effect after the Apply Address softkey is pressed.
•If the CIDR is set to None, the setting for Host/Net will be treated as a Host address.
•If the CIDR is set to other than None, the setting for Host/Net will be treated as a Net address.
• In this case, the Host-ID part of an address specifies 0. If it specifies other than 0, Invalid will be
displayed in the Status section.
• The address setting is automatically changed to 1.0.0.1 when the address was set to 1.0.0.0 and
the Host/Net setting is changed from network to host.
Table 5-2 Input Items on the [Network Setting] Screen (continued)
Input Field Description