User manual

5-20 N9360A Multi UE Tester CDMA2000 User Manual
5 Description of Screens
• Apply Address: Applies the changes of IP Addr, Mask, Default
Gateway, Host/Net, Gateway, and CIDR to the Tester. This
softkey is not activated when the [Network Setting] screen
is displayed and no setting is changed. This softkey is
activated when any input field is changed. After applying
the settings, this softkey is inactivated again.
• Cancel: Returns to the [Configuration] screen. Values
changed before the Apply Address softkey is pressed revert
to the former values.
Screen Field
Set the input items required to use the Tester, referring to the
description shown in Table 5-2.
Table 5-2 Input Items on the [Network Setting] Screen
Input Field Description
IP Addr Sets the IP address of the Tester. Possible values are as follows:
• 1.0.0.1 to 223.255.255.255. (From 192.168.1.1 to 192.168.1.255 are unavailable to
setting.)
• The IP address setting supports Class A through C.
• The Tester does not support Class D (multicast address) and Class E (reserved address).
• The default IP address is 192.168.0.1.
• If the IP address setting fails, Invalid is displayed in the Status field.
• Changes to the IP address is effective after pressing the Apply Address softkey.
CIDR (Mask) Sets the subnet mask in CIDR format. Allowable setting values are as follows:
• 1 to 31
• The default mask value is 24 (255.255.255.0).
• If the mask value setting fails, Invalid is displayed in the Status field.
• Changes to the mask setting is effective after pressing the Apply Address softkey.
Refer to Appendix B General information on cdma2000 system for details.