User manual

Operating Procedure 4

N9360A Multi UE Tester CDMA2000 User Manual 4-69

Set the mobile phone to transmit the bursted RF signal.

10 Start a test with the following operation.

• When the trigger mode is

Sing, single measurement starts

after the Trigger softkey is pressed.

• To change the trigger mode to

Cont in order to start

continuous measurement, press the Trigger Sing/Cont

softkey. When the trigger mode is

Cont, continuous

measurement starts as soon as the [TX Analyzer:

Stand-by] screen is displayed.

11 During continuous measurement, press the Trigger Sing/Cont

softkey to terminate continuous measurement. A screen

showing measurement results is displayed.

Figure 4-58 [TX Analyzer: Stand-by] Screen