User manual

4-48 N9360A Multi UE Tester W-CDMA User Manual
4 Operating Procedures
Figure 4-37 [Configuration: Test Condition] Screen
5 Set the input fields with the CURSOR CONTROL knob. Set
the GSM mode to
GSM.
6 Change the Current System to GSM and set the required
parameters such as Loss value of GSM. Refer to the
N9360A Multi UE Tester GSM User Manual for GSM
settings. Return the Current System to W-CDMA after
set-up is completed.
7 Start Manual Test.
Press the Return twice and then the Manual Test softkeys to
start Manual Test. The [Manual Test: Stand-by] screen
shown in
Figure 4-38 is displayed.